I love to start the morning from a cup of fragrant coffee. In the country, this usually happens in the fresh air in a secluded quiet place, where only the sun is closed and the singing of birds and buzzing bees, i.e. This is a moment of a certain relax. I hold a cup with a saucer in my hands and one day I remember that it is not entirely convenient, you need a coffee portable table.
I went to look for breed materials for this subject. In the attic discovered the lid of the old chest, the tree is strong.
I take an electric jigsaw, outlining the circle of the desired diameter (just on top put the cover from a large pan and circled with a pencil) and drinking the base.
Cleaning the surface with emery paper from old paint to perfect evenness, it was not difficult to do.
The legs for the table noted on the old frame from something.
At first embarrassed the absence of one leg, but thought, and why the table should be on four legs. The round form will make it stable and three.
So, I remove the legs from the frame.
They turned out to be different lengths, cut the tops and everything fell into place.
Skinted all the details of the primer and white paint and fastened the legs to the bottom surface of the table with the help of self-tapping screws.
Now decoration. I wanted to use the decoupage (I have not been "betrayed for a long time), but in the kitchen, except for purely white napkins, found only with the image of peonies.
Put off the legs and side part of the table saturated with pink color, which is present on the napkins.
Further, in fact, the decoupage part of the design and the table will be ready.
First planned to lay out fragments of drawings over the entire surface, divided the napkin to pieces,
But he stopped on a one-piece bouquet at the top of the table. Since it is not small, which leads, usually, to uneven distribution, an old proven method applied.
Cut the file, smeared the surface with liquid glue PVA, put the napkin with the outside.
Again covered with glue and gently attached the file (it over the picture) to the desired site. With a dry cloth gently spend from the center to the edges of the picture, thereby I release air bubbles and ravine it under the file. If somewhere it turns around, they are easy to fix. After making sure that everything is OK, I remove the file, the napkin lay tightly on the surface.
In order not to have sharp extreme color transitions, the tassel made drawing. That is, white paint walked over the surface of the napkin. I do it with dry tassel point movements. Little stuck and sharp green color in the same way. He dried, drove a thin layer of varnish. When it is not at hand, it is possible to replace it with thick PVA glue - it also forms a film.
Actually, everything is easy, the durable table is ready.
