In my post, I want to show you how I did a knife for the lady. Yes, as it is not surprising, she has such a desire. My husband has a beautiful and I must also have. Appointment is cooking during the departure of nature and other little things there. The main thing that he was bright and sharp. Wishes of women -zakon.
The whole manufacturing process was met in 35 photos. There will be several video of some steps and the final review of the finished product, it will be at the end of the post.
Yes, the post will be long. I did not prepare. But the road is asset going. Here the main start.
The first thing was ordered a set for further work.
Birch tree stabilized tree.
The metal strip is already tempered and leather in the tone of the handle.
The whole process begins with the manufacture of a blade. First of all, draw a future product. Tool set I think clear.
The length of the blade was needed 123 mm, width 26.
Now we are too superfluous.
In Grender, with the help of the "bulldozer" he is in the photo, make descents on the blade.
It takes quite a lot of time. Who is interested in details can see the video link. There I disassembled in detail.
Next, polishing blade with diamond pastes. Do not forget the blade for the lady and must glitter. Long-term lesson and dirty. I went to this for more than 7 hours.
There is also a review on this topic.
Pretty poverty, got a wonderful result. You can look at the blade as in the mirror.
The blade is ready to do not scratch it, protect the painting scotch, moving on. It is necessary to make a friend. To do this, sculpt a piece of nezilber and place future hole.
Gently outlining and drill holes. It is impossible to make wrong here.
A strip of a thickness of 2.5 mm, 2 mm holes.
Next, one rectangular on the shape of a shank is obtained from a plurality of round holes. Maximum fitness. There should be no cracks. This will immediately apply not the corrected harm to aesthetics.
In this case, I got everything wonderful. Bruce villages tight and without gaps.
I place and drill holes in the bar under the shank.
Also from 3 round holes we make one rectangular. The depth of it is 10 cm.
This will help to keep the shank well.
It remains only to glue and give to dry.
The next day, you can proceed to handling the handle. Just gradually remove the extra.
Gradually making square round.
While the handle is flat drill a hole under the future donkeeper tube.
Clean the unnecessary from the sides.
Insert the tube.
Remove the rude tree on Grinder, turn to manual polishing.
Gradually reducing the hijanity stripes of sandwich.
The shape of the handle is predicted, it's time to polill the Bruce.
Now he shines.
I impregnate the handle and remember for drying. It will take this day.
The knife is almost ready. Now it's about the sheath. The first make the liner.
In two rugs we remove unnecessary, then bonding.
Make a round again round, stepping unnecessary.
I cut the skin on the future elements of the knife and send it to soap.
I form a knocked and soften skin on the knife and leave to dry.
After drying, I place and drill holes under the thread.
I flash and cut off unnecessary.
I grab a little and cook with a hlystics.
Re-all walked a little and make a small embossed on the skin.
While the sheath is dried with a knife and checking the sharpness on paper. Cuts well.
Now the finish polishing of the grip grip and cleaning of the blade.
The knife and sheath are ready only to impregnate the skin with cream and sew the suspension.
So everything is ready. Now the photo is more of a decent quality.
3.
five.
For the most patient. Overview of a knife in nature. Everything is better seen there.
Everything. The photo is over.
Beauty!
A source