I want to share a small master class to felting a scarf of the cage. It will be very useful for beginners.
Materials:
- yarn - mohair (80%) and lace (50/50),
- Merinos wool, Babi Alpaca, Viscose and flax fibers,
- Well, all the necessary attributes for felting - puffer film, soap solution, film, pipe-rolling))
The layout starts with the fibers of the viscose over the entire surface of the future score)) I spray them with thin strands of Merinos wool. The yarn is starting laying on the contour of the scarf, rings. I lay the whole scarf, moving along the spiral.
For note: When laying 165 x 38 after felting, I have stably gets size 150 * 25
I do not like uneven edges very much, so in the contour I bury the yarn in two or three rows.
Before the second layer of yarn, the entire surface sprinkle with thin strands of Merinos. Attention: strands stick out only for photo, for clarity !!! You should not be like that))))))))
The queue of the second layer of yarn. Here, the ranks of the rings are broken, but it does not have much importance, you can upload along the contour)))
I wanted fluffiness, so I decided to add clouds from the Bebi Alpaca wool)))))
You can see so much)))
I add strands of Merinos between the clouds of Alpaca and I still post the Merino framework along the contour.
General form.
Queue for wicked fibers. Do not regret.
Next - Waples of golden flax. I regretted that I did not add more luna, darling color, as a result - I did not have enough contrast)))
From the pulverizer, with a large height (1 m), water dust falls, covering all our beauty)))) add more water, not less than half liters, so that everything is good)))) Attention: with a sprayer you need to be careful not blow all our beauty)))
I cover the film from above)) learn? These are two garbage packages, cut and laid))) I press everything well, smoothed, so that there are no trouble when we wipe everything into the roll))) then everything rides once 500-600)))
I will say right away that I rarely use the machine, if only a complex drawing, literally five seconds to consolidate it or on large products, but at the final stage)) I would say that there is no rules, there is a personal experience of each master, everything else It is necessary to perceive only as "tips")))
I adapted to roll like this: I screw everything on the pipe, then wrapped in a towel (so as not to slip and not spinning) I ride three minutes. I rewind on another pipe. During rewind, I look through the edge, so as not to be warmed, did not come down. And so- 4 times)
Rolling was born as needed so it was too lazy to deploy a long three-meter scarf to wrap on the other hand, which urgently found the second pipe but no matter what or on two pipes rolling-rolling, you should always carefully look at all the edges, so as not to be wrapped, did not come down, especially if there are all sorts of tails, the leaves protruding during the edges))
After rolling in a roll, remove the film, wear gloves)) I use gloves for hairdressers. I pass the entire surface of the Sharfi, without fanaticism, but convincingly)))))) I pay attention to the edges.
Usually, I wash off from the product about half of the soaps under the crane, pouring a warm driver with a warm water and I felt until readiness))) Periodically, I pull out, press, we press, looking through, smoothed, etc. etc. .... ))) etc. etc. come with experience)))))
Then we are well rolled, press, neatly, rovingly straighten and smoothed.
Here, my scarf is already smoothed, lies, glitters)))))
And this is curls fibers of flax)))))
Scarf soft and fluffy)))))
And I see it through it)))))))))
Another scarf in the same technique, but already out of three types of yarn. Decorated with brushes.
And Made to the Kit Berecher)))
That's it! Place on health)))