Slippers from fur with their own hands as a gift

Most often in private houses in winter, very cold floors. Therefore, to preserve health, it is recommended to wear warm room slippers. Now it is often possible to find fur products: vests, slippers, booties. But if you make them do it yourself, they will warm them much better.

In this article you will learn how to sew home slippers from fur.

Master Class: Tailoring of homemade slippers with their own hands

It will take:

• pattern;
• Fleece;
• Soft skin for insoles;
• fur.

Home slippers can be done both from artificial fur and from natural, it all depends on your capabilities and desires.

How to make a pattern?

There are two ways to create patterns for slippers from fur:

1. Print ready, zooming or reducing then if necessary.

1. Make yourself on the size of your foot.

1. To make a sole, we supply summer slaps along the contour. Cut 2 pcs of such details.

1. We take one of the details and cut in half. Apply halves at a distance of 7-8 cm on paper and circle. The resulting item of the sock is trying on the leg and cut off too much.

1. We measure the width of a flat part of the nose detail Slipper (W1) and put the point, postponing from the edges of 3.5 - 4 cm. Then we measure the length of the insoles (D1).

1. We make a rectangle size sh1hd1. We glue it to the details of the nose and cut the middle in it, as shown in the photo, at the points set, leaving the smooth stripes on the sides. Pattern for our slippers is ready.

Tailoring slipper

With the help of the pattern cut 6 parts:

• Fleece sole;
• Fleece sole with allowance;
• Top Detail of Flis;
• top part of fur;
• Sole with mechanism from fur;
• Sole of leather.

In order to make a part with an allowance, it is necessary to the contour of the existing grids, add 4-6mm.

1. We sew parts with mechanics from fur and fleece among themselves. Fur must be turned into inside.

1. We take the sole of the fleece without an allowance and sew it to the workpiece made.

1. Insert the fur billet into the fleece and sew on the upper edge, leaving the turning hole.

1. So that the fleece is on the outer part of the sample, and the fur is inside. We sew left hole.

1. We sew a leather insole in the paper stitch to the workpiece, you can make it in advance in the skin of the hole for the needle.

Our warm and completely non-slip fur slippers are ready!

A source