If pants hise: Correction patterns

In finished trousers or at the stage of fitting, the missing width can be obtained by issuing the intake of side and step seams of the rear halves of trousers.

Master class

Burdastyle.ru.

But in order to correctly make corrections in the paper pattern, you first need to make the pants layout on it.

How to perform wet-thermal treatment of men's trousers

STEP 1

First, delete the line of the direction of the share threads exactly along the middle of the rear side of the trousers.

To expand patterns, draw two auxiliary dotted lines:

• at the knee level - a horizontal line, exactly at a right angle to the line of the equity thread direction;

• From the vertex of the outlet to the point of intersection of the direction of the direction of the equity thread and the knee line.

The pattern cuts exactly in the middle of the molding, then along the auxiliary line to the knee line and then along the knee line close to the side sections.

Step 2.

At the level of the vertex, add the missing width, spreading the edges of the client of the wedge converging at the knee. To draw out a new outlet with a top of exactly in the center of the gain. If necessary, add a little width along the step slice.

How to reduce pattern

Step 3.

To lengthen the pattern through the vertex of the molding, carry out auxiliary horizontal line perpendicular to the line direction line. The press is drawn to draw the vertical line in the middle between the side slice and the outlet. The pattern is cut from the horizontal line from the back of the middle close to the side slice and the vertical line from the top slice close to the horizontal cut. The edges of the horizontal section are shifted by the wedge on the magnitude of the elongation: on the rear average seam by 1-2 cm, the vertical section is 0.5-1 cm. Thanks to this increase in the vertical section, the required second swelling appears. Since the initial swallow began to be very deep due to the width of the width, it should be reduced by half an increase and expand the new outtage to the same. To draw out a new outlet for 2-3 cm shorter initial. Align the side cut. Extend the line of direction of the share thread from the bottom of the pattern to the upper cut. The former direction of the direction of the equity thread at the top of the pattern is now invalid.

A source