"Black Cobra"

Suspension "Black Cobra"

Well, now MK (Filigree) Master - Class "Technique Filigree" Snake "Cobra" In order to make a snake, we need the following tools: a glass board two pieces (on one we will cut the plates for our product, and on the other ), Clay itself (in our case, the "Prado" color of the onyx), the blades are thin, scalpel, stack, the "FIMO" gel, various auxiliary needles and our sketch.

On the ploa-car roll down the reservoir

For plasticity and clay strength, you can add a little gel

And mix to homogeneous mass

Further define the basis of our snake and cut out on the main board, on which we will bake.

And remove unnecessary residues.

And get such a worm.

Now we will slide all the irregularities and give him a neat form

Thoroughly stretched the surface of our board so that it does not printed on the finished product.

That's what we got

Let's start lay out the contours: a hood, tail. Striped thin mode

And carefully remove

We put one side of the hood of our cobra

And, with the help of any devices, give the right form.

And alternately lay out the contours of the other parts.

That's what we did

Go to the most jewelry and most complex part of our jewelry: Curls - the pretzels are not very long, but thin (as far as possible, thin strips)

Carefully, with the help of a stack, remove with two fingers the tip of the strip twist into a small curl.

We get pretzels. The stack of it is drawn and put into the hood of our snake.

And so the pretzels for the pretzel all the other details.

With the help of a scalpel, I cut off and smoothed, and at the same time I combine the poverty curl

We continue to execute the outside of the second hood.

We spread curls that the curls look beautiful and gently.

Now the back is made up simply with thin arcs.

We continue again with curls.

Now we decorate rhinestones: we will make white rhinestones on the abdomen, and the eyes of green rhinestone.

All is ready. We put to bake for 25 minutes at 110 degrees. We take out and let me cool a few minutes. After neatly (only very neat, as the design is very fragile) remove from the board.