Nowadays, the archers laid universalized industrialization - went to the store or opened the catalog - and all the soul wishes - treks, feathers, tips, and - about the miracle of civilization - Ponoklaki
There is a way out of this position for those who want to do everything with their own hands. The device is not as difficult, in the end, the modern branded design is simply more comfortable for the user at the expense of some details, and the main principle is to fix the pen along the arrow's batch can be provided with self-made devices.
So - the apparatus is made of plywood (preferably high-quality), plus some small details will be required - glue and screws for the frame assembly, a pair of lines in 15cm (preferably metal), a pair of stationery binder clamps, and something else on trifles.
The design itself consists of a base of about 20 cm long and two strings with curly cuts at a distance of 15 cm from each other fortified based on. Sizes, by the way, are not fundamental and may vary. On the racks themselves are made for the clamp (the grooves are cut, or two adjustments are made - not fundamentally). The clamp itself for the plumage to make the easiest of the two metal strips (one shorter than several minutes, so that only one "sash" to break into the groove is important in order to freely remove the clamp with the pen after the fitting). The top side of the clamp is bonded by a pair of rings in the hole, forming some "sash".
The feather of the plumage placed in the clamp is fixed by a pair of stationery binders.
It will still be necessary to screw in the side ends the basics of a pair of screws, and pluck the rubber ring for fixing the clamp on the tree, placed in the base grooves. To one rack, it is necessary to attach a spring-loaded plate - it will serve as a retainer for stomaging the strip at a given angle of 120 degrees. As a scale, a conventional hex nut is used, tightly reliably on the end of the ride, pre-wrapped in tape for avoiding damage.
The order of use is simple - the pen is placed in the clamp, fixed by the binders, the end is labeled with glue, the clamp on the guides is inserted into the rack and pressed to the tree is fixed with a rubber ring. After setting the glue, the binder is removed, the clip is freely removed, the antisode turns 120 degrees - and the cycle is repeated.
Source - Various Best Forums (in particular Guns.ru) Plus a couple of their ideas