Coffee and tea cups can be stored on the shelf or in the closet, but they take a lot of space, and every time it is not always convenient every time. It is much more convenient when the stand with cups stands right on the table. In this article we will tell you how to make a wooden stand for cups with your own hands.
Materials and tools:
- Wooden pole diameter 30 mm
- Wooden pole diameter 16 mm
- Wooden pole diameter 6 mm
- Rule
- pencil
- hacksaw
- stationery knife
- Drill with drills with a diameter of 16 and 6 mm
- 4 nails about 50 mm long
- a hammer
- A bit cement mix
- Spatula or Kelma
- Malyan Scotch
- Plastic container
- level
- carbon black
- Paint brush
- mineral oil
- sandpaper
How to make a stand from wood with your own hands
The fattest helper will be the "trunk" of our stand. Screw the 30-millimeter pole with a length of about 45 cm. The branches of the tree-stand are made of medium poles, pre-dried on a segment of about 20 cm.
Billets carefully treat sandpaper.
From one of the ends of Tolstoy Gherdie, step 2.5 cm and apply a pencil mark. This end will be a vertex of the barrel. Then put two more checks at a distance of 12 cm from each other. With the help of a drill and a 16 mm drill in the trunk, drill through holes.
Note: The average opening must be perpendicular to the extreme.
So that the cups do not fall from the "branches", you need to install limiters at their ends. To do this, closer to the ends of each branch, drill on a non-splitting hole with a diameter of 6 mm. Pre-set a 6 mm pole on a length of about 2 cm.
Sample all the details, and then disassemble the design.
In the lower edge of the largest pole, you need to drive four nails.
Mix the cement solution and pour the mixture into a plastic container with a diameter of about 20 cm.
Tip: The mixture should fill the ass by about 2-2.5 cm.
Insert the central axis of the stand nails down so that they are inside the cement mixture. Align the pole and fix it in a vertical position using a painting tape. Give the mixture to frozen within 48 hours.
Remove the container support, process the cement base with sandpaper.
Insert branches into the holes, putting them on the joinery glue. Make sure the holes for the limiters look up.
Install the limiters by pin to each hole a bit of glue.
Give adhesion to dry.
Cover all wooden parts with mineral oil, thanks to this, the tree will look better and will serve longer.
Stand is ready, it remains to hang on her cups.
A source