How to make a hole in the glass? Here you have two simple ways.

Anonim

How to make a hole in the glass / 3734205_sdelatvertherestievstekle2 (490x339, 26kb)

There are such cases when you need to make a hole in the glass. In fact, it is not so simple. In this article, you will learn a couple of ways to solve this problem.

How to make a hole in the glass / 3734205_sdelatvertservstekle1 (248x120, 5kb)

If necessary, make a hole in the glass, for example, to hang the mirror or insert the handle in the glass door of the cabinet, you can use the data and uncomfortable methods:

For the first way, you need: Glass itself, metal drill, drill, acetone, turret, alcohol. To drill a hole in the glass you need to put it on a flat surface, for this you can use a large plywood sheet, the edges of the glass should not be filled.

The speed of rotation of the drill on the drill is set to the "unit" or on the "minimum", depending on the drill configuration. It is necessary to exclude strong drill bit so that the glass is not crackled when drilling, it is better in this case a drilling machine.

How to make a hole in the glass / 3734205_sdelatvertherestievstekle2 (490x339, 26kb)

Acetone, or with alcohol degrease the surface of the glass in the place where we will drill it. The drill is put into the center of the alleged hole, the drill turns on, when drilling, you need to drip down the glass, in the drilling site, turpentine. You can simply make a small mug of a funnel from plasticine and pour turpidar into it.

How to make a hole in the glass / 3734205_SDELATOTVERSTIEVSTEKLE3 (200x197, 5kb)

So that the glass is not cracked, pressing the drill is needed easily, without more effort.

In the second way, glass, solder, in the form of lead, or tin, the sand is wet small, the wand, sharpened under the cone, and the tip of the sticks must have the diameter of the intended hole, you need alcohol or acetone.

The work is done like this: the surface of the glass is degreased in the place where the intended hole will be. Sand poured into the drilling site, a slide centimeter in three in height. In the sand make a hole with a wand so that a funnel formed, melted solder pour into a funnel.

How to make a hole in the glass / 3734205_SDELATOTVERSTIEVSTEKLE4 (183x187, 11kb)

A minute later - two remove the sand from the surface of the glass, withdraw the solder, the hole is paid. Before working, it is better to check the technique and try to make a hole in the glass on an unnecessary fragment.

And now our traditional video:

A source

Read more